- Easy to apply
- UV resitant
- Highly water resistant
- Contains no biocides or toxic ingredients
- Safe for use on children's toys
- Not suitable for high tannin content timbers e.g. Oak
- Will not flake or peel
- Creates the naturally greyed effect of aged Cedar whilst till protecting the timber.
Suitable for: internal
Treatex Grey Cedar Oil works best on unfinished timber. Previous finishes which stop Grey Cedar Oil penetrating into the timber (e.g. paint and other ‘closed’ finishes) must be fully removed prior to application. Previous porous finishes should be lightly sanded before overcoating. When overcoating a previously finished surface, a trial application is essential. Flaking or peeling finishes must be fully removed prior to application. Ensure the timber is dry and free from possible contaminates e.g. algae, grease, dirt, dust etc. Timbers susceptible to decay, mould and fungi should be treated first with a suitable preservative. We advise that when using Grey Cedar Oil, sufficient product is purchased to complete the whole project and when more than one tin is required it is advisable to mix them together before use. Timber must have a moisture content below 18%. Temperature must be greater than 8º𝖼 during application and drying. We strongly recommend a trial application prior to starting the project.and external use
Recommended timbers: Cedar and Larch
Applications: cladding, windows and doors
Stir tins thoroughly, before and during use. Use a brush or roller to evenly apply Treatex Grey Cedar Oil in the same direction as the wood grain, allowing approximately 60-70ml per m². Pay particular attention to end grain, on end grain apply liberally. After approximately 12 hours the first coat can be overcoated. Apply with a brush or roller a second coat of Treatex Cedar Oil, again allowing roughly 60-70ml per m². After the second coat leave for approximately 12 hours to dry.